Trích dẫn Gửi bởi inhainha Xem bài viết
Bác nói đúng rồi, mới điện hỏi chủ bãi thì được biết nó nằm trong máy gì đó chế tạo ic.
Theo bảng 7-2 thì dòng ra của đầu phát được điều khiển analog trong dãy điện áp 0-4v bác ah. Theo bảng 7-2 thì bộ này rất dễ sử dụng. Giờ chỉ còn vấn đề thử nghiệm sức mạnh của nó thôi.


In order to use the ANALOG connector to control the system, pin 18 must first be pulled low in order to activate pins 2 and 6. Setting pin 18 high returns control to the graphical interface.
For example, to set the diode current to 40 A, first apply 2 Vdc to pin 2 (referenced to pin 22), then pull pin 18 low. This command will override any diode current command sent via the graphical interface. When pin 18
goes high again, the value set previously via the graphical interface will once again be asserted. It is important to preset the conditions you want before changing command sources. Otherwise the system might assume an unknown state.
đúng rùi bác
dòng này nó giống nhau nên datasheet đó dùng chung cho tất cả model, ở những trang đầu nó có giải thích thông số của máy thông qua model đó